Keep two sets of instructions together: the care guidance for your printed film and the operating manual for your generator. This guide concerns the graphic surface. It does not replace equipment maintenance or the directions supplied for the materials on your project.
Keep the material details
Ask your installer to identify the film, laminate or finish and provide the applicable care sheet. Record the installation date and retain the project paperwork. Those details make it easier to get useful advice if the appearance changes or a panel needs attention.
Before cleaning, consult the generator’s operating manual and your service provider.
Use a gentle cleaning approach
For the graphic surface, follow the film maker’s directions for a compatible mild cleaner and soft cleaning materials. Avoid abrasive scrubbing. Remove ordinary surface contamination before it becomes difficult to clean, and ask about an unfamiliar stain before trying a stronger chemical.
Do not aim a pressure washer at the generator or vinyl edges. Film-cleaning guidance does not override the equipment’s restrictions on water exposure. Keep water away from openings and electrical components, following the generator manual.
Avery Dennison: Vehicle Wrap and Graphics MaintenanceGeneral printed-film care reference. Follow the instructions for your actual film and generator; this is not a generator-specific product approval.
Notice small changes early
Look for lifting edges, peeling, unusual discoloration or damage during a routine visual check. Take a close-up and an overall photo, then contact your installer. Avoid pulling a loose edge, adding household glue or applying heat as a first response.
Photographs and the material information help the installer decide whether the area needs a closer inspection. If access to a panel is needed for generator maintenance, tell the service provider that graphics are present and coordinate any necessary wrap work.
Ask about service life and removal
There is no single lifespan to promise for every generator wrap. The specific material, exposure, surface condition and care all need to be considered. Ask for the applicable written product and workmanship terms rather than relying on a general estimate from a concept image.
When you want to change the design, arrange a surface assessment and a removal plan. Do not assume that an older finish or previously repaired panel will behave like a new factory surface.
Related questions
How should I clean the wrapped surface?
Follow the care sheet for the actual film and finish, together with the generator manual. Use compatible gentle cleaning methods, avoid abrasive scrubbing and do not direct pressure washing at the equipment or graphic edges. Ask your installer about unfamiliar stains.
Read the related guideHow long will the wrap last?
Service life depends on the material, exposure, surface condition and care. Ask for the specific written product and installation terms for your project. WYG does not promise one lifespan for every generator and setting.
Read the related guideCan the design be changed or removed later?
Ask for a surface assessment and a removal plan. The condition of the underlying finish matters, particularly on older or repaired panels. Do not assume removal will be damage-free on every surface.
Read the related guideTurn the idea into a project brief.
Choose a design, compare it in the Studio and keep your model details together for review.
On this test site, Studio saves stay in your browser and project drafts are downloaded, not submitted.
